thông số gia công thép không gỉ 304. Nhận ngay Wall Thickness (mm), Min Wall (mm), Safety Factor cho thông số gia công của bạn.
Sai số costing bao nhiêu? Hãy tính cho một job shop scenario. Nếu Máy Tính Độ Dày Thành của bạn quá mức 15%, bạn không chỉ mua thêm dao phay đầu Ingersoll — bạn đang trả cho thời gian chết bất ngờ, gia công lại, và trễ hạn giao hàng.
| Premature Sumitomo Electric tool failures | $6,400/yr |
| Unplanned machine downtime | $12,200/yr |
| Rework / scrap parts | $8,700/yr |
| Excess Haimer holder wear | $2,100/yr |
| Total Annual Loss | $29,400/yr |
Đảo ngược kịch bản. Bằng cách tối ưu Máy Tính Độ Dày Thành — sử dụng thông số khởi đầu khuyến nghị của nhà sản xuất cho dao cụ Ingersoll hoặc Sumitomo Electric cụ thể, xác minh trên máy đo trước Tesa — bạn có thể thu hồi gần 30.000$ mỗi năm. Đó là đầu dò dao Matsuura mới hoặc một năm lượng dao phay Ingersoll.
ROI tức thì. Chi tiết đầu tiên được tối ưu, ngày đầu tiên tiết kiệm.
Wall thickness determines the strength and pressure capacity of tubes, pipes, and hollow components. This calculator computes the actual wall, minimum required wall under internal pressure, and the resulting safety factor.
Thin-wall (Barlow's formula) applies when wall thickness is less than 10% of the inner radius. It assumes uniform stress through the wall. Thick-wall (Lame formula) is needed for hydraulic cylinders and high-pressure vessels where stress varies through the wall — use for wall/radius ratio over 0.1.
4:1 is standard for industrial hydraulics per ISO 4413. Aircraft hydraulics use 4:1 on proof pressure (typically 1.5x working pressure). Test pressure is usually 1.5-2x working pressure. A manifold rated at 210 bar (3000 psi) should withstand 840 bar burst pressure.
The allowable stress in the formula depends on the material yield strength and safety factor. 6061-T6 aluminium (yield 240 MPa) requires thicker walls than 7075-T6 (yield 470 MPa) for the same pressure. Stainless 316 at 200 degrees C has only 70% of its room-temperature strength — derate for elevated temperature.
Enter the outer diameter, inner diameter, internal pressure (if applicable), and material allowable stress. The calculator shows wall thickness, minimum required wall under pressure, and the safety factor. For hydraulic applications, maintain at least 4:1 safety factor on ultimate tensile strength.
Continue with closely related tools from the machining calculator library.
Gửi cho chúng tôi vật liệu chi tiết, loại nguyên công, kích thước lô và yêu cầu dung sai. Chúng tôi sẽ kết nối bạn với nhà máy phù hợp và có giá trong vòng 48 giờ.
Khám phá thêm công cụ và máy tính gia công chính xác